RAMPS 1.4 Control Panel 3D Printer Control Board Reprap Control Board for Arduino Mega 2560
-550x550.jpg "RAMPS 1.4 Control Panel 3D Printer Control Board Reprap Control Board for Arduino Mega 2560")
-80x80.jpg "RAMPS 1.4 Control Panel 3D Printer Control Board Reprap Control Board for Arduino Mega 2560")
- Stock: 1
- Model: 3A001
- Weight: 110.00g
RAMPS 1.4 Control Board Panel Part Motherboard 3D Printers Parts Shield Red Black Controls Ramps1.4 Boards Accessories
Ramps 1.4:
It was designed as a low-cost small package RepRap needs to accommodate the entire electronics . Oblique interfaces with the powerful Arduino MEGA platform Arduino Mega , and have plenty of room for expansion. On the stepper drives and a Arduino MEGA shield extruder control electronics for easy maintenance , replacement parts , upgrades and expansion capabilities , including plug-in modular design . In addition, some Arduino expansion boards can be added to the system , as long as the main ramp plate is saved to the top of the stack .
The board is mainly based on Adrian 's Pololu_Electronics and work Tonok 's . The proposed anti- Vick copper etching method . Vick is also inspired by the work of EasyDrivers . Adrian'sPololu_Electronics circuit design mainly based on Joaz RepRapSource.com provide initial pin definitions and many design improvements. Too much inspiration , advice, and from Prusajr, Kliment, Maxbots, Rick, and many other ideas RepRap community.
Features:
- It has Cartesian robots and regulations of the extruder .
- Extended to control other accessories.
- Heater / MOSFET outputs and three fan thermistor circuit.
- Integration of additional security 5A and component protection
- Control of additional heating bed 11A fuse
- Suitable for 5 Pololu stepper driver board
- Pololu board pin socket, so they can be easily replaced or removed for future designs .
- I2C and SPI pins left for future expansion.
- Hooked into all MOSFET PWM pin versatility.
- Servo type connector is used to connect to the end stop , the motor and the light-emitting diodes. These connectors are gold-plated , rated current of 3A, very compact.
- On the SD card to add - is now available from the Kliment - Sdramps
- LED indicate when the heater output
- Option 2 motors connected to Z Prusa Mendel
