DC brushed motor is the most commonly used and widely available motor in the market. Getting the motor to rotate is fairly easy, just connect the two terminals to power source and it will start spinning, that's the beauty of DC brushed motor. Yet, if you want to control the speed, direction, activat..
Building a mobile robot with Arduino? Want to control high power stepper motor? Look no further! SHIELD-MDD10 is a 2-channel high power motor driver shield for Arduino. It is able to control two brushed DC motors or single bipolar/unipolar stepper motor from 7V to 30V. With discrete N..
The MDD20A enables bidirectional control of two high-power brushed DC motors from 6V to 30V. With full discrete NMOS H-Bridge design, this motor driver is able to support 20Amp continuously for each motor without any heatsink.A lot of motor drivers in the market specify their current ratings ac..
It has multiple holes shell for heat dissipation, good heat dissipation and long service life.The DC motor speed control module is made of high quality electronic components, which has high stability and can maintain high stability in harsh environments.The potentiometer is used for speed regulation..
100% Brand new and high quality!Top entry pinsIncludes 3-axis gyro, accelerometer and high-performance barometerOnboard 4 MegaByte Dataflash chip for automatic dataloggingBarometric pressure sensor upgraded to MS5611-01BA03, from Measurement Specialties.Atmel's ATMEGA2560 and ATMEGA32U-2 chips for p..
Ramps 1.6Ramps 1.6 is optimized and launched based on Ramps 1.4 & Ramps 1.5The Structure almost same as Ramps 1.5 , the difference is Ramps 1.6 have new 2pin connectors, which more simple and convenient to connect, also will not be burnt easily, what's more ,Ramps 1.6 have a good Heatsink above ..
1) Working voltage DC 10V-35V. DC24V switching power supply is recommended.2) the use of high-speed optical coupling 6N137, ensure high speed without losing step.3) Toshiba TB6560AHQ new original chip, there are low-pressure shut-off, overheating parking and over-current protection circuit to ensure..
* Product Name: Universal IR Remote Control* Model Number: S08* Input: DC 5V/1A(Micro USB)* Standby Power Consumption: <0.85W* Infrared Frequency: 38KHz* IR Remote Control Distance: ≤8m* Connection: Wi-Fi IEEE 802.11 b/g/n 2.4GHz* App: Support Android 4.0/iOS 8.0 or later* Working Temperature: 0~..
Building a RC vehicle or mobile robot without any microcontroller? MDDRC10 is what you need. It's plug and play and can be connected directly to the RC receiver. No coding or programming is needed. Selectable mixed mode allow the differential drive motors to be controlled from a throttle (forward-re..