DC brushed motor is the most commonly used and widely available motor in the market. Getting the motor to rotate is fairly easy, just connect the two terminals to power source and it will start spinning, that's the beauty of DC brushed motor. Yet, if you want to control the speed, direction, activat..
Building a mobile robot with Arduino? Want to control high power stepper motor? Look no further! SHIELD-MDD10 is a 2-channel high power motor driver shield for Arduino. It is able to control two brushed DC motors or single bipolar/unipolar stepper motor from 7V to 30V. With discrete N..
The MDD20A enables bidirectional control of two high-power brushed DC motors from 6V to 30V. With full discrete NMOS H-Bridge design, this motor driver is able to support 20Amp continuously for each motor without any heatsink.A lot of motor drivers in the market specify their current ratings ac..
5 Channel Tracking Sensor Tracking Module Infrared Sensor TCRT5000L5 Channel Tracking Sensor Tracking Module Infrared Sensor TCRT5000LHigh-Quality Tracker SensorThe module is a convenient carrier for eight IR emitter and receiver pairs evenly paced.Distance between each IR Sensor: 15mmUses 5 sensors..
Five channel flame sensor design, wide range of detection (the detection range of the ordinary single flame sensor is probably about 30°, as the distance increases, the range is gradually reduced, the detection range of the product is greater than 120°)Able to output a digital signal (high and..
100% Brand New and High Quality!Remotely control your switch wherever you areDurability.Tempered glass protects from,deformation and fading.Easy to maintain and clean.Toughened Glass,protects from scratches and scarring.Damp Proof.Works even in humid conditions.Locate in darkness.Soft light and cris..
DescriptionIf you need a DC brushed motor driver that can accepts signal from:RC (Radio Control)PWM of microcontrollerAnalog voltage of Potentiometer/Variable ResistorUART/Serial command of microcontrollerWell, this motor driver is perfect for you, and it supports upto 10Amps (continuous) each chann..
Looking for a motor driver for your mobile robot? Want to drive a stepper motor? Worry not! MDD3A is able to control two brushed DC motors or single bipolar/unipolar stepper motor from 4V to 16V. With discrete MOSFETs H-Bridge design, this motor driver is able to support 3..
• 200/100/60MHz bandwidths•1GSa/s Real Time sample rate• Large (7.0-inch) color display,WVGA(800x480)• Record length up to 1M• Trigger mode: edge/pulse width/line selectable video/slop/overtime etc.• USB host and device connectivity, standard• Multiple automatic measurements• Four math functio..
Batteries Required?NoBatteries Included?NoManufacturer recommended age16 years and upManufacturer reference1Parcel Dimensions22.1 x 21.59 x 10.67 cm; 481 GramsASINB07V3ZG9LN..